Car Accessories

Headquartered in Mumbai with manufacturing units in Rajasthan & in the industry since 1986, we are primary manufacturers & distributors of all Industrial Chemicals, Acids, Solvents and Mineral Products.

We're registered dealers of M-TEK Body Kits, Front Protection Guards, Roof Luggage Carriers, Side Steps, Rear Protection Guards & Diffusers, Roof Rails / Garnish, Spoilers, Arm Rests, Bike Rack, etc.

Cars
1) Mahindra Scorpio, Bolero, XUV 300, Marazzo, XUV 700
2) Toyota Crysta
3) Maruti Brezza, Eeco, Ertiga, XL6, S-Presso, Swift, Dzire, Wagon R, Celerio, Alto800, Ignis
4) Hyundai Creta, Venue, Aura, I20, I10
5) Tata Safari, Harrier, Nexon, Punch, Tigor, Altroz, Tiago
6) Renault Triber 
7) Kia Seltos, Sonet, Carnival
8) MG Hector
9) Commercial Vehicles like Ace, HT, Xenon, Yodha, Maximo, Cruiser, Dost

We're registered dealers of all Morel Car Audio Systems. 

We've a team of very experienced installers in Mumbai. We also travel to other cities for installation at an additional conveyance cost. 

We also courier/ transport these audio systems all over India 

Premium Quality 7D Mats for all cars available in various color options

Headquartered in Mumbai with manufacturing units in Rajasthan & in the industry since 1986, we are primary manufacturers & distributors of all Industrial Chemicals, Acids, Solvents and Mineral Products.

We're registered dealers of all Cerwin Vega Car Audio Systems. 

We've a team of very experienced installers in Mumbai. We also travel to other cities for installation at an additional conveyance cost. 

We also courier/ transport these audio systems all over India 

We're registered dealers of all JL Audio Car Speakers & Amplifier Systems. 

We've a team of very experienced installers in Mumbai. We also travel to other cities for installation at an additional conveyance cost. 

We also courier/ transport these audio systems all over India 

• A three-layered material: 1. Self-adhesive glue layer for installation, protected with anti-adhesive paper 2. Our advanced formula composite butyl polymer 3. Aluminum foil
• The material is installed at dry clean painted metal surface. Temperature in workroom must be from +18 to +30°??. Material is released from protective tint and is pressed carefully to work surface. Care should be taken to avoid air chambers in the material, which admit moisture and reduce insulation properties. Do not install material on the dirty and on the corroded metal surface.
• Recommended area of installation: Medium (NANO) – Doors, roof, boot lid and bonnet lid
• Products stored in a room at a temperature no higher than +40°C in the horizontal position on a flat surface at a distance of not less than 1 meter from the heating system in the conditions excluding moisture, oils and direct sunlight, stacked no more than 1 meter in height.
• Made In Russia

Premium Leather 7D Mats from Auto Tech